After you have purchased your floating shelves we will choose the most suitable concealed fixing brackets to send. This is based on the size of your shelf, the weight it has to carry and the construction of your wall.

Your floating shelves will be manufactured to accommodate either the Screw type bracket or for the Re- Bar system both pictured below. Unless we are notified that your floating shelves will be installed on a plasterboard or cavity wall, and then the shelves will be manufactured to accommodate the Plate Bracket.

The Screw Type Concealed Fixing Bracket

Our most widely used fixing bracket. We recommend these when your shelf is being fixed to a solid wall (Brick or Block) and your shelf is no deeper than 300mm. They are very easy to fit and will hold a weight load of up to 35kg on a shelf width of approx 1000mm up to a maximum 3000mm in one length

These Concealed Fixing Brackets are available to purchase

please press here.

The Re-Bar system

These are resin fixed steel bars. Suitable for solid walls Only. To be used when you are going to put heavy loads on your shelves. Will support 50kg upwards. Also used when shelves are over 300mm deep

These Concealed Fixing Brackets are available to purchase please press here.

The Plate Bracket

The Plate Bracket can be used when you are fixing your floating shelves to a cavity wall, a ply wall or a plaster board wall. They can be fixed with plasterboard fixings

(not supplied unless asked for at the point of purchase please call 0207 903 5383  to request)

Please note when fixing to these types of wall the weight capacity of your shelves is dramatically reduced. Also 50mm thick shelves and shelves over 250mm deep should not be used when fixing to these types of wall.

These Concealed Fixing Brackets are available to purchase please press here. 

We hope this page has been helpful.